MTM Trapezium Mill adopts numbers of national patents, such as trapezium working surface, flexible connection, roll linked pressure boosts etc. It has completely overcome defects of traditional mill in amplification fields, capacity, fineness, energy consumption and service life etc.

MTM Trapezium Mill Operation:

(1) START
Before starting the grinder, to check all the doors and ensure they are closed properly, to check and ensure the jaw crusher is open wide enough for the raw materials, to adjust and ensure the speed of the Classifier is suitable to the required specification of powder-products.
Then to start the operation in the following sequence:
1. To start the bucket elevator.
2. To start the jaw crusher.
3. After the storage is filled with stuff waiting for process, to start the Classifier.
4. To start the blower (first without load, then with load added).
5. To start the grinder, immediately to start the electrical-magnetic vibrating feeder.
So the whole set is operating.
START: Elevator->Crusher ->Classifier ->Blower ->Grinder Feeder
(2) STOP
Turn-off procedures:
1. To stop the feeder.
2. About one minute later, to stop the grinder.
3. after blowing al the leftovers, to turn off the blower.
4. Last to turn off the Classifier.
STOP: Turn-off Procedure: Feeder->Grinder->Blower->Classifier
If there are some reserves in the storage, the jaw crusher should be switched off before the elevator. This rule depends of the amounts of the reserve in the storage.
During the operation, adding grease is permitted for sake of safety.
In case of any abnormal noises from any parts of the set and the sudden increase of load, the operation should be stopped, the equipment checked, and the troubles got rid of, in order to prevent any accidents.

Welcome to Shanghai Zenith Company.If you want to more information about our products, Please online chat or give us the message, we will reply as soon as possible.